Investigation Axial Global Directional in ANSYS Software of Concrete Mixed Beam Structures Volume 1 - Issue 1

Semih Taskaya¹* and Selim Taskaya²

• ¹Department of Engineering Metallurgy and Materials, Faculty of Technology, University of Firat, Turkey
• ²Department of Architecture and Urban Planning, School of Vocational, University of Coruh Artvin, Turkey

Received: September 24, 2019   Published: October 10, 2019

Corresponding author: Department of Architecture and Urban Planning, School of Vocational, University of Coruh Artvin, Turkey

 

Fulltext PDF

To view the Full Article   Peer-reviewed Article PDF

Abstract

The model structure of the coordinated systems under the name of concrete-mixed beam structures using ANSYS 12.0 software was designed in 3D. Concrete mixture was selected as the element type of the model structure. Model prototype was created by measuring distance dependent with 16 coordinate points. Mesh segmentation was applied to the 3D concrete mixed beam model and 75 N/mm² load and 32.174ft / sec² acceleration motion were applied to the carrier systems. In the results of the application, global directional changes between the model groups were examined. As a result of the global investigations, ANSYS software has determined that the mechanical improvements should be at the joints where the beams connected to the axes and the concrete bases meet.

Keywords: Concrete mixtures; Beams; ANSYS; Global; Axial

Abstract| Introduction| Experimental| Results and Discussion| Conclusion| References|