Analysis of Tensile and Shear Strength Research Results of
a Deformable Adhesive in a Lightweight Floor System
Volume 1 - Issue 5
Jacek Karpiesiuk*
-
Author Information
Open or Close
- Department of Building Expert in construction and building, Bialystok University of Technology, Poland
*Corresponding author:
Jacek Karpiesiuk, Department of Building Expert in construction and building, Bialystok University of
Technology, Poland
Received: June 26, 2019; Published: July 05, 2019
DOI: 10.32474/MAMS.2018.01.000122
Full Text
PDF
To view the Full Article Peer-reviewed Article PDF
Abstract
The article statistically analyzes experimental tests on a light floor system (LFS) without screeds. The results of over two years
of experiments in which the strength of C2S1 and C2S2 cement deformable adhesive for tensile and shearing were tested allow
to determine the confidence interval for the expected value of these strengths along with determining the relative precision of
the estimation. In the article, only the C2S1 adhesive was analyzed because it meets two important criteria. It has relatively high
mechanical strength and is more economically advantageous (purchase price 2-3 times lower than C2S2). The obtained data also
allowed to verify the hypothesis regarding the minimum strength of the C2S1 adhesive during the pull-off test and shear strength.
Keywords: Deformable adhesive C2S; Statistical analysis; Lightweight floor system; Experimental research
Abstract|
Introduction|
Results of Calculation|
Conclusion|
Acknowledgement|
References|