The Personalized Design and Production of Indirect
Bonding Technology Based on CAD and RP Technology in
Orthodontics
Volume 4 - Issue 5
Huifang Yang*1 and Siwei Wang2
- 1Center of Digital Dentistry, Peking University School and Hospital of Stomatology, China
- 2Department of Orthodontics, Peking University School and Hospital of Stomatology, China
Received: April 24, 2021 Published:May 10, 2021
Corresponding author: Huifang Yang, Center of Digital Dentistry, Peking University School and Hospital of Stomatology, National
Center of Stomatology, Research Center of Engineering and Technology for Digital Dentistry of Ministry of Health and Beijing Key
Laboratory of Digital Stomatology, China
DOI: 10.32474/MADOHC.2021.04.000199
Fulltext
PDF
To view the Full Article Peer-reviewed Article PDF
Abstract
Objective: This paper introduces a method to make a transfer tray for indirect bracket bonding by using the Three-Dimensional
(3D) software packages. Using the advanced technology of Computer-Aided Design (CAD) and Rapid Prototyping (RP) technology
to reduce chair time and improve the bonding precision in orthodontics.
Method: The procedure included data acquisition of cast model and CBCT data. With the data, the tooth was segmented one by
one, and the segmented data was saved as Stereolithography (STL) files. The tooth data and the cast data could be seen in a same
3D digital software and with the data the bracket position was decided by doctors. The transfer tray was designed in a reverse
engineering software and printed by a 3D printing device.
Result: The method was used to make an individualized transfer tray in orthodontics.
Conclusion: With 3D scanning, CAD and RP technology, an efficient method of transfer tray production was established, which
could meet clinical needs in indirect bonding of orthodontic and achieve a high efficiency and accuracy
Keywords: Transfer tray; CAD; Bracket; Indirect bonding; RP
Abstract|
Introduction|
Materials and Methods|
Results|
Discussion and Conclusion|
Acknowledgment|
References|